Prym Atelier Iron-On Patches (4-pack)

Ironing on patches is a simple alternative to sewing them on with a needle and thread. However, it requires careful preparation and technique to ensure that the patches stay in place. Here are some important tips:

1. Set your iron to the highest setting without using steam, and let it preheat thoroughly.

2. Lay the fabric where the patch will be applied smooth on the surface to avoid wrinkles.

3. Pre-iron the area where the patch will be placed to remove wrinkles and warm up the fabric.

4. Place the patch smoothly and straight on the garment and cover it with a thin cloth to protect it.

5. Use the hot iron to iron from the inside out, allowing the adhesive in the patch’s transfer tape to melt, and pay special attention to the edges and corners.

6. Iron for about 20–30 seconds with medium pressure to ensure that the patch adheres well.

7. Turn the fabric inside out and iron it a little more.

Note that patches should only be ironed onto cotton fabrics, as synthetic fibers can be damaged by the heat and the adhesive. On synthetic or blended fabrics, patches should be sewn on instead.

Iron-on patches can be washed in the washing machine, but it is advisable to wash them on the delicate cycle at a low temperature. To increase the stability of the patches during washing, you can secure the edges with running stitches.

If patches come loose over time, you can use fabric glue to reattach them.